For people who have been cycling with steroids for some time and get some first hand knowledge of the industry, we all know that raw powders are much more economic than finished products. However, the process of preparing their own finished injectables is still quite distant from us, and sounds like a work that need a lot technical knowhow.
In fact, it is very simple, and almost everyone could operate it with simple equipments!
Just get prepare the following materials and we are ready to go!
1.) Assemble Your Materials
It is important to have everything you will need at hand, the best way to cook is to do everything quickly. This prevents fluctuations in temperature and excessive oxidation of your compounds – both allow the compound to reach its strength potential and many ‘cooks’ do not allow for this. Set up your water bath by boiling the kettle and adding a 2-3cm of the boiling water into the base of a pan, or similar container – work quickly from this point so the water temperature does not drop by too much. 150f is ideal for the temperature of this water but it is not greatly important.
2.) Select the recipe from our Hormone Recipes Page.
Depending on what you are planning to make select the appropriate recipe from our Recipes Page and adjust if required, if the recipe is for a 10g conversion you must just half the amounts used for a 5g conversion. Weigh the appropriate amount of Steroid powder into the glass beaker and then add the correct amount of Benzyl Alcohol according to the recipe you are using. In this example the following recipe is used:-
3.) Dissolving & Warming.
Add the Benzyl Benzoate according to the recipe you are using and place the glass beaker in the water bath, sitring vigorously until the powder is fully dissolved (no grains at the bottom).
4.) Add The Carrier Oil.
Once fully dissolved add the warmed carrier oil (Grape-Seed oil reccomended) and stir while heating until all the ‘Hormone Swirls’ are gone, then remove from the heat.
Draw up the mixture into the syringe you will be filtering with, remove the 0.22um Sterile Syringe filter from its packaging and fix the green needle to the smaller side and then apply to the syringe. Wipe the top of the sterile vial with an alcohol swab and put a green needle in it, and then put the needle attached to the syringe filter into the vial:
You have now successfully completed the process of producing Hormones. It is a very straight forward process and requires no expertise. In this example Trenbolone Acetate.
For more information, please contact Sylvia.
Phone: +86 13418710728
Whatsapp/Skype: +86 13418710728.
Contact Person: Ms. Wendy
Tel: +86 13798562250